Normal scrub speed?

[Dice]

Hey,

I haven't checked in on my machine in a while, completely forgetting what scrub speeds used to be.
I wonder - just from the first glance, would this look legit?

Code:

20.9T scanned out of 29.3T at 386M/s, 6h20m to go
		0 repaired, 71.29% done

...single vdev raidz2 6xWDRED6TB @ LSI 9201-16i?

 

[Stux]

Round about what I see for scrubs, yet resilvers are blazing fast. Maybe scrubs are lazier?

 

[nojohnny101]

hmmm. You can view my setup in my signature for my primary system. I have manually performed two scrubs that I actively monitored. The scrub started out at around the speeds you described (in the 50m/s range) but after about 30 minutes it peaks out at where it hold for the remainder of the scrub around 525m/s.

 

[Dice]

Round about what I see for scrubs, yet resilvers are blazing fast. Maybe scrubs are lazier?

yeah, the numbers posted on resilvering in your thread was the spark to put up this thread rather than going OT in yours..
Blazing resilvering speeds while I was watching a scrub at orders of magnitude slower..

You can view my setup in my signature for my primary system. I have manually performed two manual scrubs that I actively monitored. The scrub started out at around the speeds you described (in the 50m/s range) but after about 30 minutes it peaks out at where it hold for the remainder of the scrub around 525m/s.

Good to know. Then this is still in the ballpark.