Migrated from Core to SCALE Cobia and one Pool broke and cannot be recreated

[OverEngineer]

I have successfully migrated CORE to SCALE cobia, but somehow it created problems with one pool.

This pool has only one WD RED PRO 8TB HDD and after the upgrade the pool was there and worked, i rebooted and the pool was offline, disk not there, this happened around 2 times when i rebooted.

This is only a HDD where some media is stored, i have it backupped somewhere else so i thought i would just recreate the pool and be done with it, on pool recreation the following error happens: Error: Error fsyncing/closing /dev/sdg: Input/output error

Then i removed the HDD from the system, to test it on my Linux system, partition was still there, i deleted it and created a test partition and written some files to it and run a short smart test, test results: https://pastebin.com/6dSMZ05K

I cleared all partitions and put it back into the Truenas system and tried to create the pool again and the same error occured.

part of the syslog: https://pastebin.com/ej6kLSJj

I also replaced the SATA cable, i have absolutely no idea what is wrong here...

 

[OverEngineer]

I have tested the HDD on Truenas CORE and Truenas SCALE in VMware Workstation, there it works normally.

I also tested another HDD in the Truenas System and with this HDD pool creation and usage also works.

I have no idea what is going on here, but it seems my Truenas installation has a problem with this HDD.....